Loading and saving programs to the control

What we offer › Forums › Lasers Forum › Loading and saving programs to the control

Tagged: 

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 16, 2013 at 9:27 pm #496
    jay
    Keymaster

    (from Larry Packman)
    Here is a web site I found informative:
    http://www.i-logic.com/serial/FanComm.htm

    Data Set Ready:
    When the external device is ready to operate to needs to set this signal high. If this signal goes low anytime during data transfer, NC alarm 86 will occur. Jump 6 to 20 if signal isn’t used.

    Since the tape reader is internal, are all the obvious switches set correctly? Does it work at all?

    November 22, 2013 at 1:51 pm #599
    jay test
    Participant

    test post – disregard

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.