Training

What we offer Forums Lasers Forum Training

This topic contains 0 replies, has 1 voice, and was last updated by  Anonymous 2 years, 7 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #1580

    Anonymous

    In the “G-Codes for Amada Lasers” page, there was some discussion of training.
    I can offer some training and troubleshooting on these older machines.
    I am located in the Los Angeles area. I worked with lasers at Amada until about 2000, so I had some familiarity with the 160-IL and earlier controls.
    But Amada and others can train on 16 and 160 controls. They may not support the older ones, and I can.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.